schuttstore
Football

Comfort Liner Helmets

  • schuttstore

    Measure the player's head as shown, 1" above the eyebrows around the widest part of the head.

  • schuttstore

    The helmet's front edge and nose bumper should be approximately 1" above the player's eyebrows.

  • schuttstore

    Attach the chin strap to the helmet underneath the faceguard, never above it. Tighten the chin strap to be snug and centered on the chin.

  • schuttstore

    Jaw pads should be snug against the player's face, flush with the jaw, without pushing too forcefully into the cheeks.

  • schuttstore

    The helmet should fit snugly, without being too tight. There should be no independent movement of the helmet.

schuttstore
Football

Inflatable Helmets

  • schuttstore

    Measure the player's head as shown, 1" above the eyebrows around the widest part of the head.

  • schuttstore

    Lubricate the pump needle generously and insert needle as shown. Do not force the needle into the port; doing so may puncture the liners opposite wall.

  • schuttstore

    Begin with the bottom port on the back of the helmet. Perform 1-3 pumps. Helmet should be snug against the player's head but not overly tight. Excess air is released with the valve.

  • schuttstore

    When finished, repeat for the top inflation port. Proper inflation will usually require 0-2 pumps, but that will vary by player.

  • schuttstore

    The helmet's front edge and nose bumper should be approximately 1" above the player's eyebrows.

  • schuttstore

    Attach the chin strap to the helmet underneath the faceguard, never above it. Tighten the chin strap to be snug and centered on the chin.

  • schuttstore

    Jaw pads should be snug against the player's face, flush with the jaw, without pushing too forcefully into the cheeks.

  • schuttstore

    The helmet should fit snugly, without being too tight. There should be no independent movement of the helmet.

schuttstore
Football

Shoulder Pads

  • Identify player position, and select the corresponding Schutt Shoulder Pads. Refer to the products in the shoulder pad section.

  • schuttstore

    Measure the shoulder span from right to left tips of the humerus.

  • schuttstore

    Wrap measuring tap around player's torso to measure chest circumference.

  • schuttstore

    Carefully lower the pads over the player's head.

  • schuttstore

    Buckle belts, and connect any straps that your shoulder pad uses. Ensure a good tight fit in chest and back areas.

  • schuttstore

    Ensure proper front coverage by confirming that shoulder pads cover the sternum, as well as front upper shoulders.

  • schuttstore

    Check to ensure that there is no pinching in collar area.

  • schuttstore

    In the back, pads should cover the scapula and rhomboid areas. Fitted properly, shoulder pads should allow player maximum motion.

Air
Baseball-Softball

Helmets

  • schuttstore

    Measure the circumference of the player's head at its widest point. This is about 1 inch above the eyebrows.

  • schuttstore

    The helmet bill should be parallel to the ground, 1 inch above the eyebrows. If a faceguard is attached, you should have an unobstructed view.

  • schuttstore

    Helmet should fit snugly, without pinching or feeling too tight. Helmet should NOT move independently of the player's head.

  • schuttstore

    Give the bill of the helmet a solid tap while the player is wearing it. The helmet shouldn't move. If it does, the helmet is too big.

schuttstore
Baseball-Softball

Chest Protector

  • schuttstore

    To determine the best size, measure from the top of the player's collar bone to the bottom of your naval. The bottom of the chest protector should rest at your naval when standing.

    Chest Protector SizeAgeHeight
    12" 9-12 4'6"-5'
    13" 12-15 5'-5'4"
    15" 15-17 5'4"-5'9"
    16" 17-Up 5'9"-6'3"
schuttstore
Baseball-Softball

Leg Guards

  • schuttstore

    To determine the best size, measure from the middle of your knee to the top of your ankle bone. Leg guards are available in sizes 13",14",16", and 17".